Installation / Operating Instructions

If connected, disconnect the DLP-TH1 from the PC now.

If the USB drivers for the DLP-TH1 have already been installed 
on this PC then uninstall them using FTClean before proceeding.
FTClean is available for download from the bottom of the page 
at www.dlpdesign.com.

1. Run DLPTraySetup.exe and click on Install.
2. Agree to the license.
3. Click on OK to use the C:\DLPDesign\DLPTray folder.
4. Click on Unzip when the WinZip Self-Extractor window appears.
5. Click on Close once the files are unzipped.
6. Click on Yes to restart the PC.
7. Connect the DLP-TH1 to the PC and load the drivers in the 
   C:\DLPDesign\DLPTray\drivers\DLPTH1UT1 folder.
8. Start the service from the Start menu: Start DLP Service.
9. Open the program setup window from the Start menu: DLPTray
10. Select the DLP-TH1 device and click on Device Alerts & Options
11. Click on the Temperature tab.
12. Click the SMTP Settings button.
13. Set up the Outgoing Mailserver Settings and send a test email. Click OK.
14. Set the temperature humidity alarm set points.

At this point the service is set up and running.  

The program setup window can be opening either by clicking on the DLP 
icon in the system tray or via the Start menu.

The service will automatically reload and run upon reboot.  Even 
though the service is running, the DLP icon may not appear in the 
system tray.

The service can be disabled via the Start menu by selecting Stop 
DLP Service.  Only the email feature of the service will be halted
when the service is disabled.

Be sure to test the system my manually exceeding the set point (by 
holding the sensor in your hand, for example) such that an email 
is sent to verify there are no further firewall issues that must 
be addressed.

The icon in the system tray will toggle during an alarm condition.

If multiple sensors are to be used on the same PC, each must be given 
a unique name.  Use the Rename button on the program setup window 
to rename each device used.