Original Nuts&Volts magazine article available for reading online
ADD A UNIVERSAL SERIAL BUS INTERFACE TO YOUR NEXT PROJECT -- IT'S EASIER THAN YOU MIGHT THINK!
added: 5-1-01
This is the article that started it all. Get the basics on the DLP-USB1 USB adapter. To read the article click here.

Nuts&Volts magazine article available for reading online
added: 12-10-01
The article describes both the DLP-IO16 and DLP-IO26 microcontroller development systems and how FTDI's FT8U245AM USB FIFO chip is used to emplement a high-speed interface to a host PC.
To read the article click here.

ChipCenter article discussing the DLP-USB1 and FTDI Drivers
added: 12-11-01
Another article, published by Circuit Cellar at the ChipCenter site is now available for reading online. To read the article click here.

Nuts&Volts magazine article available for reading online
added: 11-27-02
This article covers the new
Bit-Bang feature of FTDI's latest USB chips.
To read the article click here.

Nuts&Volts magazine article available for reading online
added: 05-13-03
This article covers the use
of FTDI's FT232BM USB-UART USB chip with a basic microcontroller.
To read the article click here.

Nuts&Volts magazine article available for reading online
added: 10-22-04
This article covers the use
of FTDI's new FT2232C Dual Channel IC, specifically the use of the MPSSE interface to form an all-serial data-acquisition system.
To read the article click here.


Nuts&Volts magazine article available for reading online
added: 03-02-07
This article covers
FTDI's new VMUSIC module based on the
Vinculum VNC1L-1A USB Host IC.

(VMUSIC1 Module)
(RFID Spokesman1)
(RFID Spokesman2)
(RFID Spokesman Schematic)
To read the article click here.

Visit Nuts & Volts magazine:



Elektor magazine article on the topid of bit-banging the FT2232H.
added: 2-1-2012
This article discusses a secure access panel that employs the bit-bang mode using the API from FTDI.
To read the article click here.

Journal Of Dental Technology article available for reading online
added: 7-5-2014
This article discusses the need for, and the application of, RFID technology as used for denture indentification.
To read the article click here.


 
   

© Copyright DLP Design. All rights reserved